如何更换油装载机中的油泵过滤器?
工具：
- 1/4 英寸 Allen wrench
- 13 mm wrench
- Oil filter wrench
- Oil drain pan
- New oil pump filter
步骤：
- Park the vehicle on a level surface and apply the parking brake.
- Locate the oil filter. The oil filter is typically located near the engine block or near the rear of the vehicle. It is a black or dark-colored filter.
- Disconnect the oil drain plug. Use the 13 mm wrench to loosen the oil drain plug and allow the old oil to drain out.
- Remove the oil drain plug. Use the 13 mm wrench to remove the oil drain plug and allow the old oil to drain out.
- Loosen the oil filter nuts. Use the 1/4-inch Allen wrench to loosen the oil filter nuts.
- Remove the oil filter. Use the 1/4-inch Allen wrench to remove the oil filter.
- Install the new oil filter. Apply a thin coat of new oil on the gasket of the new oil filter. Screw the new oil filter onto the oil filter nuts by hand until snug.
- Tighten the oil filter nuts. Use the 1/4-inch Allen wrench to tighten the oil filter nuts in a star pattern. Tighten the nuts until snug, but do not overtighten.
- Replace the oil drain plug. Use the 13 mm wrench to replace the oil drain plug.
- Fill the engine with new oil. Use the oil filler hole in the engine to fill the engine with new oil.
- Start the vehicle and check the oil level. Add oil as needed until the oil level reaches the "full" mark on the dipstick.
Tips:
- Use a new oil filter every 15,000 to 20,000 miles.
- If the oil filter is clogged, it can cause a loss of power, rough idling, and increased oil consumption.
- If you are not comfortable changing an oil filter, you can take the vehicle to a mechanic.
