如何更换油泵阀体滤器?

工具：

*wrench *socket set *oil filter wrench *new oil pump filter

步骤：

1. Park the vehicle and turn off the engine.
2. Locate the oil filter. It is usually located near the engine block or near the rear of the vehicle.
3. Disconnect the oil filter from the oil pump. Use the oil filter wrench to loosen the nuts that hold the filter in place.
4. Remove the old oil filter. Use the wrench to loosen the nuts that hold the filter in place.
5. Install the new oil filter. Apply a thin coat of new oil to the gasket on the new filter. Screw the new filter onto the oil pump until it is snug.
6. Tighten the nuts on the new oil filter until they are snug.
7. Replace the oil filter. Tighten the nuts on the new oil filter until they are snug.
8. Start the engine and check the oil level.
9. Add oil to the engine until the oil level reaches the full mark on the dipstick.
10. Check the oil pressure. Use the dipstick to check the oil pressure. The oil pressure should be within the normal range specified in the owner's manual.